Shift Cable - Arctic Cat ROV 2013 Service Manual

INSTALLING
1. Install the shift axle supports onto the shift lever;
then secure the axle supports to the frame with four
cap screws and tighten to 48 in.-lb.
2. Secure the shift cable end to the shift arm stud with
the cap screw and nut. Tighten to 8 ft-lb.

Shift Cable

REMOVING
1. Remove the dashboard (see Dashboard, Removing in
this section).
2. Remove the nut securing the shift cable to the shift
arm stud; then loosen the upper adjuster nut on the
shift cable and remove the shift cable from the shifter
assembly.
3. Tilt the cargo box back and remove the E-clip from
the shift arm on the transmission; then loosen the
adjuster nut on the shift cable housing and remove
the shift cable from the transmission.
4. Remove the center floorboard and remove all nylon
HDX168
ties securing the cable housing to the frame; then
remove the shift cable.
 NOTE: If the cable is being replaced, connect the
new cable to the end of the cable being removed and
pull the new cable into place.
INSTALLING
1. Route the cable into position making sure there are
no kinks or sharp bends.
2. Install the cable housing onto the transmission
holder; then connect the cable end to the shift arm
and secure with the E-clip.
3. Install the shift cable into the shift cable support;
HDX166A then connect the shift cable end to the shifter and
secure with a cap screw and nut. Tighten to 8 ft-lb.
4. Adjust the shift cable (see Shift Lever - Adjusting
Shift Cable in the Periodic Maintenance section).
5. Install nylon ties on the shift cable where removed;
then install the center floorboard and tighten the
machine screws securely.
6. Install the dashboard (see Dashboard, Installing in
this section).
HDX178A
HDX137B
HDX132A
145