Troubleshooting - Arctic Cat ROV 2013 Service Manual

INSTALLING
1. Place the fuel pump assembly into the gas tank with
a new gasket aligning the match marks; then secure
with the four screws. Tighten securely.
NOTE: It is important to install the fuel pump with
the correct orientation to ensure adequate float
lever clearance.

Troubleshooting

Problem: Starting impaired
Condition
1. Gas contaminated
Problem: Idling or low speed impaired
Condition
1. TPS out of adjustment
Problem: Medium or high speed impaired
Condition
1. High RPM "cut out" against RPM limiter
2. Connect the gasline hose to the fuel pump pipe and
secure with the hose clamp; then connect the electri-
cal plug to the main harness.
3. Connect the negative battery cable; then turn the
ignition switch to the ON position and verify that no
gas leaks are present, the pump runs for 2-3 seconds,
and the gas gauge reading is normal.
4. Start the engine to verify proper engine operation;
then shut off the engine and install the seat base, seat
back, and seat.
Remedy
1. Drain gas tank and fill with clean gas
Remedy
1. Adjust TPS
Remedy
1. Decrease RPM speed
75