Arctic Cat ROV 2013 Service Manual page 114

 NOTE: The grease pack contains 120 grams of
grease. The inside joint (double-offset) requires
approximately 70-90 grams of grease and the outside
(bell-type) requires approximately 35-55 grams. When
replacing boots, use 2/3 of the pack for inside boots
and 1/3 of the pack for outside boots.
CAUTION
Do no over-fill the joint as boot damage may occur
resulting in joint failure.
9. Slide the new outside boot onto the shaft with the
new clamps positioned as shown. Note the different-
sized clamps from removal.
 NOTE: The boot is positioned correctly when the
small end of the boot seats down into the recessed
groove.
10. Using CV Boot Clamp Tool, secure both outside
boot clamps.
CAUTION
The clamps must be positioned correctly or they may
loosen when in motion.
ATV-1052
ASSEMBLING AXLES
1. Install the inner boot with the small clamp making
sure the ends of the clamp are positioned correctly.
 NOTE: The boot is positioned correctly when the
small end of the boot seats down into the recessed
groove.
2. Using the boot clamp tool, secure the small clamp of
the inner boot.
CD754
3. Apply 80 grams (2/3 of contents) of grease from the
pack into the bearing housing.
4. Install the bearing onto the shaft making sure the
recess of the bearing is facing the housing.
CD024
CD754
ATV-1048
111