Arctic Cat ROV 2013 Service Manual page 134

11. Remove the snap ring from the ball joint; then remove
the ball joint from the A-arm.
CLEANING AND INSPECTING
NOTE: Whenever a part is worn excessively,
cracked, or damaged in any way, replacement is
necessary.
1. Clean all A-arm components in parts-cleaning solvent.
2. Clean the ball joint mounting hole of all residual Loc-
tite, grease, oil, or dirt for installing purposes.
3. Inspect the A-arm for bends, cracks, and worn bush-
ings.
4. Inspect the ball joint mounting holes for cracks or
damage.
5. Inspect the frame mounts for signs of damage, wear,
or weldment damage.
INSTALLING
1. Apply Loctite Primer "T" to the A-arm socket; then
apply green Loctite #609 to the entire outside diame-
ter of the ball joint. Install the ball joint into the A-arm
and secure with the snap ring.
AF610D
2. Install the A-arm assemblies into the frame mounts
and secure with the cap screws. Only finger-tighten at
this time.
AF616D
3. Route the brake hose through the upper A-arm shock
absorber mount.
4. Secure the lower eyelet of the shock absorber to the
upper A-arm. Tighten nut to 20 ft-lb.
5. Secure the A-arm assemblies to the frame mounts
(from step 2). Tighten the cap screws to 35 ft-lb.
6. Install the knuckle assembly onto the ball joints and
secure with cap screws. Tighten to 35 ft-lb.
AF616D
AF610D
AF627D
131