Arctic Cat ROV 2013 Service Manual page 64

2. Apply a liberal amount of engine oil to the crank-
shaft bearing. Using a propane torch, heat the bear-
ing until the oil begins to smoke; then slide the
crankshaft assembly into place.
NOTE: If heating the bearing is not possible, the
crankshaft can be installed using a crankshaft
installing tool.
3. Install the crank balancer.
MT014
NOTE: It will be necessary to rotate the crank bal-
ancer until the counterweight is facing away from
the crankshaft; then rotate the crankshaft clock-
wise into the journal area to allow the crank bal-
ancer to be fully seated.
4. Place the key into the crank balancer keyway; then
install the crank balancer gear making sure the align-
ment dots on the crank balancer gear and the crank-
shaft gear align.
CC688
5. Install the driveshaft.
CC689
6. Place a washer on each end of the countershaft
assembly; then install the assembly.
CD832B
CD826A
CC675
61