Arctic Cat ROV 2013 Service Manual page 19

4. Install one of the V-belt cover cap screws into the
driven pulley fixed face; then turn the cap screw
clockwise to spread the pulley faces. Remove the V-
belt.
16
INSTALLING
1. Place the V-belt into position on the driven pulley
and over the front shaft.
CD963
NOTE: The arrows on the V-belt should point
forward.
2. Pinch the V-belt together near its center and slide the
spacer and movable drive face onto the driveshaft.
Secure the drive face with a washer and nut (coated
with red Loctite #271). Tighten the nut to 165 ft-lb.
CD966A
Make sure the movable drive face plate is fully engaged
onto the splines of the clutch shaft before tightening the
nut or false torque readings may occur. This will cause
the assembly to loosen damaging the shaft and clutch
face plate.
PR476A
NOTE: At this point, remove the cap screw from
the driven pulley face.
3. Rotate the V-belt and driven pulley/clutch until the
V-belt is flush with the top of the driven pulley.
4. Place the V-belt cover gasket into position; then
install the cover and secure with the cap screws mak-
ing sure the different-lengthed cap screws are in their
proper location. Tighten the cap screws to 8 ft-lb.
5. Install the seat, seat back, and seat base.
GZ085
CAUTION
GZ085
GZ485A