Arctic Cat ROV 2013 Service Manual page 117

 NOTE: For servicing bearings or seals, see Front
Differential in this section.
Installing/Shimming
 NOTE: Ring gear clearance must be adjusted prior
to selecting shim for the thrust button.
1. Install the thrust button with shim into the gear case
cover and tighten securely (left-hand threads).
2. Place the ring gear with selected shim into the cover
and measure the ring gear to thrust button clearance
with a thickness gauge. Clearance should be 0.002-
0.004 in.
3. If clearance is as specified, remove the ring gear and
thrust button; then place a drop of red Loctite #271
on the threads and tighten to 8 ft-lb (left-hand
threads).
4. If clearance is not as specified, repeat steps 1 and 2
using thicker shim (clearance too great) or thinner
shim (clearance too small) until correct specification
is reached.
REAR DRIVE INPUT SHAFT/
HOUSING
Removing/Disassembling
1. Remove the cap screws securing the rear drive input
shaft/housing to the rear gear case; then remove the
input housing assembly.
114
2. Remove the input shaft from the input housing; then
remove the oil seal.
GC057A
GC058A
3. Remove the snap ring retaining the input bearing and
using an appropriate bearing driver, press the bearing
from the housing.
GZ183
GZ180
GZ182A
GZ184A