Lcd Gauge; Front Wheel Alignment; Front Fascia/Front Bumper - Arctic Cat HDX 700 2017 Service Manual

5. Shift the transmission through all positions making
sure the each gear position illuminates the appropri-
ate gears selected and that Park Indicator illuminates
only when fully in Park. Adjust as necessary.
6. Install the center footrest, seat base, seat back, and
seat.

LCD Gauge

REMOVING/INSTALLING
To remove the gauge, pull out on one side of it; then dis-
connect the multi-pin connector and remove the gauge.
PR900
To install the gauge, connect the multi-pin connector and
press the gauge into the dash.
 NOTE: Ensure the rubber mounting ring is ori-
ented correctly on the tab and seats fully through the
dash.
WT601A

Front Wheel Alignment

NOTE: All measurements and adjustments must be

made with the vehicle unloaded.
Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 0-6 mm (0-1/4 in.) greater
than the rear measurement (toe-out).
28
PR087A
1. Center the steering wheel; then using an open-end
wrench to hold the tie rod ends, loosen the right-side
and left-side jam nuts.
UTV-374B
PR792
CAUTION
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.
2. Turn the left-side and right-side tie rods in equal
increments to achieve the proper toe-out; then
tighten the jam nuts to 8 ft-lb.

Front Fascia/Front Bumper

REMOVING
1. Lift the hood and remove the access cover seal; then
remove the push pins securing the front access panel
and remove the panel.