Checking The Damper - KTM 690 enduro R EU Repair Manual

9 SHOCK ABSORBER, SWINGARM
9.15

Checking the damper

–
Remove seal ring retainer
300542-10
–
Remove locking cap
300543-10
Condition
The damper has been disassembled.
–
Measure the inside diameter at both ends and in the center of the damper car-
tridge.
Damper cartridge
Minimum diameter
» If the measured value is greater than the specified value:
–
Change the damper cartridge.
–
Check the damper cartridge for damage and wear.
» If there is damage or wear:
201280-10
–
Change the damper cartridge.
–
Measure the diameter of the piston rod.
Piston rod
Diameter
» If the specification is not reached:
–
Change the piston rod.
–
Measure the run-out of the piston rod.
Piston rod
300554-10
Run-out
» If the measured value is greater than the specified value:
–
Change the piston rod.
–
Check the piston rod for damage and wear.
» If there is damage or wear:
–
Change the piston rod.
.
7
and rubber buffer .
8 9
46.10 mm (1.815 in)
≥ 17.95 mm (≥ 0.7067 in)
≤ 0.03 mm (≤ 0.0012 in)
46