Optional Network; Wireless Network - Kyocera TASKalfa 306ci Operation Manual

Setup and Registration (System Menu) > System Menu

Optional Network

[System Menu/Counter] key > [System/Network] > [Optional Network]
Configure settings for the optional network interface kit.
NOTE
This menu is displayed when the optional network interface kit or Wireless Network Interface Kit is installed.
Basic
Item
Host Name
TCP/IP Setting
LAN Interface
MAC Address Filter
Restart Network
*1 The setting will be changed after restarting the device or network.

Wireless Network

[System Menu/Counter] key > [System/Network] > [Wireless Network]
Configure settings for the optional Wireless Network Interface Kit.
Setup
NOTE
This function is displayed when the optional Wireless Network Interface Kit is installed.
Item
Connection Status
Quick Setup Wizard
Available Network
Push Button Method
PIN Code Method
(Device)
PIN Code Method
(Terminal)
Check the host name of the machine. Host name can be changed from Command Center RX.
Changing Device Information (page 2-50)
For details on setting value.
TCP/IP Settings (page 8-29)
IPSec (page 8-33)
Select the LAN Interface type.
Value: Auto, 10Base-Half, 10Base-Full, 100Base-Half, 100Base-Full, 1000BASE-T
NOTE
This function is displayed when the optional network interface kit is installed.
Select whether to use MAC Address Filter.
Operation Guide for the optional network interface kit
Value: Off, On
Restarts the network card of the device.
When the optional Wireless Network Interface Kit is installed, you can check the wireless LAN status.
If the machine will connect to an access point that supports the automatic wireless network setup,
connection settings can be configured by Quick Setup.
Select access points to which the machine can be connected, Enter the Preshared Key and
start a connection.
If the access point supports the push button method, wireless settings can be configured using
the push button. This setting executes push button, and the connection is started by pressing
the push button on the access point.
NOTE
The push button method supports only the WPS.
Starts connection using the machine's PIN code. Enter the PIN code into the access point. The
PIN code of the machine is automatically generated.
Starts connection using the PIN code of the access point. Enter the PIN code of the access point.
8-35
Description
*1
Description