Obtain Nw User Property - Kyocera TASKalfa 306ci Operation Manual

User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration

Obtain NW User Property

Set the required information to obtain the network user property from the LDAP server. The user name and E-mail
address obtained with this setting is shown in the user information, the status confirmation screen, and the header of
E-mail.
NOTE
To obtain the network user property from the LDAP server, [Network Authentication] must be selected for the
authentication method in "Enabling User Login Administration". Select "On" for "LDAP" in "Protocol Detail".
Enabling User Login Administration (page 9-3)
Protocol Detail (page 8-31)
The table below explains the required information to be registered.
Item
*1
Server Name
Port
*2
Name 1
*3
Name 2
*4
E-mail Address
*5
Authentic at Type
Search Timeout
*1 If using Active Directory of Windows, the server name may be the same as the server name entered in the network
authentication.
*2 If using Active Directory of Windows, displayName of Attribute may be used as "Name 1".
*3 "Name 2" can be left out. When you assign displayName in "Name 1" and department in "Name 2", and if the value of
displayName is "Mike Smith" and the value of department is "Sales" in Active Directory of Windows, the user name appears as
"Mike Smith Sales".
*4 If using Active Directory of Windows, mail of Attribute may be used as E-mail Address.
*5 Appears when the server type is set to "Kerberos" in "Network Authentication".
1
Enter the LDAP server name or the IP address (up to 64 characters). If a server name is
not entered, user information will be acquired from the server set for Network
Authentication.
Port number for LDAP server. The default port number is 389.
Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server
(up to 32 characters).
Enter the LDAP Attribute to obtain the user name to be displayed from the LDAP server
(up to 32 characters).
Enter the LDAP Attribute to obtain the E-mail address from the LDAP server (up to 32
characters).
Set the authentication method. Select [Simple] or [SASL]. After changing the setting,
restart the system or turn the power off and then on.
Set the amount of time to wait before time-out in seconds (from 5 to 255 seconds).
Display the screen.
1
[System Menu/Counter] key > [User Login/Job Accounting]
NOTE
If the user authentication screen appears, enter your login user name and login
password and select [Login]. For this, you need to login with administrator privileges.
The factory default login user name and login password are set as shown below.
Login User Name:
Login Password:
2
[User Login Setting] > [Obtain NW User Property] > [On]
Descriptions
3000
3000
9-23