Power Switch; Reset Switch; System Id Led - Fujitsu PRIMERGY TX120 User Manual

d Hard disk failure LED
This LED is lit or blinking depending on the hard disk status as follows.
LED status
Off
Amber
Amber (blinking slowly)
Amber (blinking quickly)
e Hard disk access LED
This LED is lit green when data is being written to or read from the hard disk.
table: Indication of hard disk access LED
LED status
Off
Green
f Maintenance switch
This switch is used only by maintenance personnel. Do not touch this.
g CD/DVD drive
It reads data or programs from a CD/DVD.
h CD/DVD access LED
This LED blinks when data is being read from a CD/DVD.
i CD/DVD eject button
Press this button to eject a CD/DVD.
Do not press this when the CD/DVD access LED is lit.
j Power switch
Press this switch to turn on the server.
Do not turn off the server when the hard disk access LED is blinking.
Data in the hard disk may be damaged.
k Reset switch
Pressing this switch resets and restarts the system.
Do not restart the system when the hard disk access LED is blinking.
Data in the hard disk may be damaged.
l System ID LED button
When this button is pressed, the system ID LED is lit blue so that the locations of devices being
maintained can be identified.
m System ID LED ( )
ID
This LED is used for maintenance. When the system ID LED button is pressed, this LED is lit
blue so that the locations of devices being maintained can be identified.
Also, the [Locate] button of ServerView can be used to light them.
table: Indication of hard disk failure LED
In normal mode or hot spare mode
Error detected in the hard disk (in an array configuration)
Rebuilding
Locating (SAS-BIOS or ServerView RAID)
Hard disk access status
Hard disk is not accessed
Hard disk is accessed
PRIMERGY TX120 User's Guide
Hard disk status
23