Turning Off The Server - Fujitsu PRIMERGY TX120 User Manual

Chapter 1 Overview
4
Press the power switch on the front of the server.
The server's power LED is lit green.
When the power is turned on, the server performs Power On Self Tests (POST). If any
abnormalities are detected by POST, error messages are displayed ("9.2.2 Error Messages"
( pg.175)).
The time to turn on the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView. For details, refer to "3.4 Serious Error Handling (ASR)" in "ServerView User's Guide".
To display the Boot Menu where you can change the boot disk, press the [F12] key right after the
POST memory amount check ("

1.4.3 Turning Off the Server

1
Open the drive cover.
"1.4.1 Opening the Drive Cover" (pg.28)
30
The server's power
LED is lit green
How to start BIOS Setup Utility" ( pg.149)).
• In the event of smoke or sparks, immediately unplug the electric cord.
Failure to do so could lead to a fire or electrocution.
• Follow the procedures below to turn off the server. Data can be lost if
these procedures are not followed correctly.