Power Cord Selection - Fujitsu PRIMERGY TX120 User Manual

Item
Rpm
Dimensions
*2
Weight
*1:The value indicates memory capacity of the formatted hard disk (1GB = 1000
*2:A Hot plug carrier is not included.
B.3

Power Cord Selection

The power cord for this unit has been packed separately and has been selected according to the country
of destination. It must be used to prevent electric shock. Use the following guidelines if it is necessary to
replace the original cord set. The female receptacle of the cord set must meet CEE-22 requirements (see
Figure).
For the United States and Canada
Use a UL listed and CSA labeled cord set consisting of a three conductor cord with a maximum length
of 15 feet. For units which stand on a desk or table, type SVT or SJT cord sets should be used.
For units which stand on the floor, only SJT type cord sets should be used.
The cord set must be selected according to the current rating for your unit.
Please consult the table below for the selection criteria for power cords used in the United States and
Canada.
table: Selection criteria for power cords used in the United States and Canada
Cord type
SJT
SVT
• Parallel
For units set at 115 V: Use a parallel blade, grounding
type
Attachment plug rated 15 A, 125 V.
table: Internal hard disk unit specifications
10,000rpm
Size of conductors in cord
18 AWG
16 AWG
14 AWG
18 AWG
17 AWG
• Tandem
PRIMERGY TX120 User's Guide
Function and specification
15,000rpm
70.1 × 100.45 × 15 (mm)
0.22kg
3
bytes).
Maximum current rating of unit
10 Amps
12 Amps
12 Amps
10 Amps
12 Amps
For units set at 230 V: Use a tandem blade, grounding
type
Attachment plug rated 15 A, 250 V.
10,000rpm
203