Power Switch Tab - Fujitsu PRIMERGY ServerView BX900 User Manual

Control via Tabs
– Maximum power consumption
– Highest possible power consumption

5.2.2 Power Switch Tab

You can power the system unit on and off using the Power Switch tab. You can also power all server blades on and
off provided the system unit is switched on. The tab contains six boxes.
Figure 45: Power Management – Power Switch tab (1/4)
Actual System Power Status
You can power off the system unit immediately (Hard Power-off, i.e. the system unit and all server blades are shut
down at one go) or shut it down gracefully and then switch it off (Graceful Shutdown And Off, i.e. all server blades
are shut down but the system unit remains in standby mode). You can power on the system unit if it has been
switched off.
Power Switch Configuration
You can choose between Automatic and Manual for the purpose of system inventory retrieval. If Automatic is set,
inventory retrieval takes place when server blades are added to the system unit and each time the system unit is
powered on. If Manual is set, inventory retrieval of a server blade must, when required, be performed by powering
the server blade on (see Components → Server Blades → Power Management).
Automatic power-off of the system unit can also be enabled when all server blades have been off for more than 30
minutes.
And for the system unit you can set power-off after the last server blade stopped.
Server Blade Power Control
If the system unit is on, you can power all server blades on and off together here. In this case the server blades
are shut down gracefully and powered off or started one after the other.
I
Here the server blades are not powered on and off in the order defined in the Server Blade Power-On/Off
Sequence box.
56
Power Management
ServerView BX900 Management Blade