Fujitsu PRIMERGY TX120 User Manual page 92

Chapter 5 Operations after OS Installation
8
Select [Custom size] and enter a value in [Initial size].
The value depends on the type of the set dump file.
Set a value larger than the value shown in [Recommended] in [Total paging file size for all
drives].
9
Enter a value in [Maximum size].
Set a value larger than the [Initial size].
10
Save the settings.
Click [Set] in the [Paging file size for selected drive] section.
The settings are saved, and the value specified is displayed in [Paging File Size] of [Drive].
11
Click [OK] to close the [Virtual Memory] window.
12
Click [OK] to close the [Performance Options] window.
13
Click [OK] to close the [System Properties] window.
14
Restart the system.
The setting is enabled after the system is restarted.
Rebooting after OS dump setting
Rebooting may not be executed when the server fails even if rebooting has been set after obtaining
dumping.
Immediate provision may be required when the server fails. However, configure the settings of
rebooting with the Software Watchdog, when continuous operation is required. For details and
configuration procedures for the Software Watchdog, refer to "3.4 Serious Error Handling (ASR)" in
"ServerView User's Guide".
92
When a smaller value is specified for the paging file size, performance may be affected. For
maximum system efficiency, be sure to set [Initial size] with a value larger than the [Recom-
mended] size described in [Total paging file size for all drives]. The recommended size is total
memory installed in the system × 1.5. However, if a program occupies a large part of memory
is regularly used, set a larger size as required.