Restoring The System - Fujitsu PRIMERGY TX120 User Manual

9.6 Restoring the System

In the unfortunate event where the system file, system configuration, or environment
changes during startup are corrupted, use the repair information stored on the
recovery disk created at the installation to restore the system.
Create a recovery disk when you have installed an OS or changed the system configuration. Refer to
"5.2 Creating a Disk for System Recovery" ( pg.93).
If the procedures of restoring the system are described in the manual of the backup devices or
Readme.txt of the device drivers, refer to these procedures.
When starting the server without setting the floppy disk in the FDD unit (USB), BIOS does not
recognize the FDD unit (USB). Make sure to connect the FDD unit (USB) and set the floppy disk
before starting the server. For details, refer to "Appendix E External Floppy Disk Drive (USB) Notes on
Usage" ( pg.216).
Items required
• Windows Server 2003 CD/DVD (Installation disc)
• Automated System Recovery (ASR) floppy disk (created beforehand)
• Backup media (created beforehand)
• Driver disk (for an onboard array controller / for an array controller card)
For details about required driver disk and how to create a driver disk, refer to "4.1 Creating Driver
Disks" ( pg.70).
1
Turn on the server and insert the Windows Server 2003 CD/DVD (Installation
disc) immediately.
Check there are no floppy disks in the floppy disk drive.
2
When the active area is specified on the hard disk, the following message
appears. Press any key while this message is displayed.
Press any key to boot from CD....
Setup window for Windows Server 2003 x64 appears.
3
The following message appears at the bottom of the window. Press the [F6]
key.
Press F6 if you need to install a third party
SCSI or RAID driver ...
PRIMERGY TX120 User's Guide
195