Notes On The Use Of Usb Memory; Notes On Power-On After Power-Off; Power Control And Operator Panel Mode Switch - Fujitsu SPARC Enterprise M3000 Product Notes

Notes on the Use of USB Memory

To execute the dumpconfig(8), restoreconfig(8) or snapshot(8) command, if
you specify USB memory as the destination to store data, prepare the USB memory
as a medium in advance.
The data stored will include the information about the system. To use USB memory,
you need to pay attention to the management of the USB memory in which the data
stored, from the data security viewpoint.
We do not provide guarantees to every USB memory from any manufacturers that
currently on the market against its connectivity to XSCF and proper operation.
Depending on the USB memory in use, defects such as the XSCF firmware error or
reset may occur. In case such defects occurred, stop the use of USB memory
immediately.
To connect the USB memory to the USB port for XSCF, connect the USB memory
directly to the USB port. If connected via USB hub or USB extension cables, it may
cause errors.

Notes on Power-On After Power-Off

Please wait at least 30 seconds before turning on the system power that you turned
off, by pulling out the power cable or using the circuit breakers on the distribution
panel.
Power Control and Operator Panel Mode
Switch
You can use the mode switch on the operator panel to switch between system
power-on/off when you use the remote power control utilizing the RCI function or
the automatic power control system (APCS).
For details, see the "Limitations and Cautions" in "Preface" of the SPARC Enterprise
M3000 Server Service Manual.
12 SPARC Enterprise M3000 Server Product Notes for XCP Version 1091 • April 2010