System Event Log; How To Use Server Management Tools - Fujitsu PRIMERGY TX120 User Manual

Chapter 9 Operation and Maintenance

9.3 System Event Log

To operate system event log, use Server Management Tools.

9.3.1 How to Use Server Management Tools

This section explains how to use Server Management Tools.
Server Management Tools perform the following to the system event log.
• Viewing the system event log
• Saving the system event log
• Deleting the system event log
When a system event log occurs, save the log using Server Management Tools and contact an office
listed in the "Contact Information" of "Start Guide".
Notes
• The "Server Management Tools" disk supplied with this server is for use with this server only. Do
not use those tools on other systems. If it is used, the system can be damaged.
• Make sure to perform this operation only when the server is started with the "Server Management
Tools" disk. Do not run Server Management Tools on the server started from the hard disk or by the
other floppy disk. Otherwise, the system may be damaged.
• Do not eject the floppy disk when the Floppy disk access LED is lit. Doing so may destroy the data
on the floppy disk.
Starting Server Management Tools
Before rebooting the system, first check that the boot monitoring function of ServerView has been
disabled (default setting is "Disabled").
If the system is started with this function enabled, the server may automatically turn off or restart
improperly.
If the boot monitoring function is needed, it should be reset to enabled before resuming normal server
operation. For details about ServerView, refer to the "ServerView User's Guide".
"Server Management Tools" disk is required to be created when stated as "blank" on the label of the
"Server Management Tools" disk supplied with the server. Create "Server Management Tools" disk by
referring to "5.4 Creating Maintenance Tools" ( pg.98).
When starting the server without setting the floppy disk in the FDD unit (USB), BIOS does not
recognize the FDD unit (USB). Make sure to connect the FDD unit (USB) and set the floppy disk
before starting the server. For details, refer to "Appendix E External Floppy Disk Drive (USB) Notes on
Usage" ( pg.216).
186