Chapter 3 How to Use the Operator Panel
3.1 Operator Panel
The operator panel consists of a Function Number Display, buttons and LED indicator.
Names and Functions
*1: For details about the setup method for a scan using the
[Scan/Stop] button or the [Send to] button, refer to the
scanner driver's Help or
"Using a Button on the
Scanner to Start Scanning" (page
*2: Pressing the [Send to] button when scanning a
document, pauses the scanning process, after the
document is scanned.
LED Indicator
Lights in orange when an error occurs.
Flashes when the ADF is open.
Check
Function Number Display
Indicates the status of the scanner.
Function
Switches off when the scanner enters power saving mode.
Send to
[Function] Button
Scan
/Stop
Switches the number (from 1 to 9/C) for the application that is launched when the
[Send to] button is pressed.
Power
[Send to] Button (*1) (*2)
Launches the linked application software.
Clears the displayed error indication.
Pauses the scan.
[Scan/Stop] Button (*1)
Launches the linked application software.
Clears the displayed error indication.
67).
Cancels the scan while scanning by pressing this button.
Resumes the scan.
[Power] Button
Turns the power on/off.
Lights in green when the scanner is turned on.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
52