Operational - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings
Waiting Time to Enter Power Saving Mode [Power
saving]
The waiting time for the scanner to enter power saving mode
can be specified.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2
From the listing on the left, select [Device Setting].
3
Use the slider to specify the waiting time before the
scanner enters power saving mode.
The value can range from 5 to 235 minutes (in increments of 5).
HINT
Selecting the [Power off after a certain period of time] check box
turns the power off automatically if the scanner is left on for a
certain period of time without being used.
You can select the timeout period for the scanner to be
automatically turned off by [1 Hour]/[2 Hours]/[4 Hours]/[8 Hours].
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
159