Operational - Fujitsu fi-7140 Operator's Manual

Chapter 5 Daily Care
3
Clean the following locations with a cloth moistened with
Cleaner F1 or a sheet of Cleaning Wipe.
Glass (× 2)
Ultrasonic Sensor (× 2)
Brake Roller (× 2)
Remove the roller from the scanner.
For details about removing the brake roller, refer to
Brake Roller" (page
Gently wipe off any dirt or dust along the grooves, taking care not to
damage the roller surface.
Brake Roller
(× 2)
Feed Roller
(× 2)
Pick Roller (× 2)
Eject Roller
Gently wipe off any dirt or dust along the grooves as you rotate the roller
(× 2)
manually, taking care not to damage the roller surface. Make sure that it
is wiped properly because black residue on the roller will affect the
feeding performance.
Document
Plastic Idler Roller (× 4)
Sensor
Gently wipe off any dirt or dust on the surface of the rollers. Make sure
(× 8)
that it is wiped properly because black residue on the roller will affect the
feeding performance.
Be careful not to damage the sponge that is attached to the middle of
the roller.
Pick Roller
Glass (× 2)
(× 2)
Gently wipe the dirt and dust off the surface of the glass sections.
ATTENTION
Vertical streaks may appear on the scanned image when the glass is
dirty.
Plastic Idler
Roller
(× 4)
"6.2 Replacing the
85).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
78