Operational - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings
Item
Brake Roller Number of sheets scanned after the
brake roller is replaced
The number of sheets is counted in
increments of 500.
Pick Roller Number of sheets scanned after the pick
roller is replaced
The number of sheets is counted in
increments of 500.
Remaining Ink Amount of ink remaining in the print
cartridge of the imprinter
(only displayed when imprinter is
installed)
ATTENTION
If you turned off the scanner by unplugging the power cable, or
selected [Disable power switch], the number of scanned sheets
may not be counted in [Total Count].
For details about disabling the power switch, refer to
Turning the Scanner ON/OFF [Power SW Control]" (page
■
Description
When you have replaced or cleaned a consumable part, reset the
corresponding counter by using the following procedure:
1
"Method of
160).
2
3
Resetting the Sheet Counters
If you have replaced a consumable, click the [Clear]
button of the consumable that you replaced. If you
performed cleaning, click the [Clear] button of [After
cleaning].
The counter is reset to 0.
For the ink counter, the value will be set to 100.
Click the [OK] button.
A confirmation message appears.
Click the [OK] button.
The settings are saved.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
138