Operational - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings
Item
Document check area
specification for Multifeed
Detection
(page 154)
Intelligent Multifeed Function
(page 157)
Number of paper feeding retries
(page 147)
Description
Selected range: Select this item to restrict the
area to run multifeed detection.
Enable/Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.
Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.
End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.
When there is a paper of the same size
attached to a designated location on the page,
configure the scanner to memorize the location
of the attachment and not detect multifeeds for
that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check
Overlapping and length] in either the scanner
driver or the multifeed detection setting in
"Specifying a Multifeed Detection Method
[Multifeed]" (page 152).
Select to clear the overlap pattern (length,
location) memorized in Auto mode.
Select to record the multifeed pattern on the
window to check an image that is detected as
multifeed.
Specify whether or not to memorize the
multifeed pattern upon power-off.
Configure this setting to change the number of
feeding retries when a pick error occurs.
Parameter/Value
[Selected range] check box
Enable/Disable
(When [Selected range] is selected)
0 to 510 mm (in increments of 2)
0 to 510 mm (in increments of 2)
Manual mode/Auto mode 1/Auto mode 2
[Clear overlap pattern] check box
[Auto-Memorize MF Pattern] check box (only
when MF images are displayed)
Remember/Do not remember
1 to 12 times
TOP
Contents
Factory Default
Index
Not selected
Introduction
Scanner
Disable
Overview
How to Load
0 mm
Documents
0 mm How to Use the
Operator Panel
Manual mode
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Not selected
Troubleshooting
Not selected

Operational

Settings
Do not remember
3 times
Appendix
Glossary
134