An Error ("E" Or Other Letter Or Number) Is Already Displayed In The Function Number Display After Power-On - Fujitsu fi-7140 Operator's Manual

Chapter 7 Troubleshooting
An error ("E" or other letter or number) is already
displayed in the Function Number Display after
power-on.
Did you unlock the transport lock switch?
(fi-7240)
Yes
Is the error code still displayed after you turned the power
off then back on?
Yes
Is the letter "c" flashing on the Function Number Display
while the LED indicator is flashing?
No
Turn off the scanner, and unlock the transport lock switch.
For details about how to turn off the scanner, refer to
No
OFF" (page 23).
For details, refer to "Installing the Scanner" in Getting Started.
The scanner is operating correctly.
No
Close the ADF and the print section of the imprinter (only when imprinter is
installed) properly.
Yes
For details, refer to "1.4 Opening/Closing the ADF" (page
If the indication does not return to the ready status ("1") after you closed the ADF,
check the items in "7.4 Before You Contact the Scanner Service Provider" (page
119) first, then contact your FUJITSU scanner dealer or an authorized FUJITSU
scanner service provider.
If the problem persists, check the items in
Service Provider" (page 119)
an authorized FUJITSU scanner service provider.
"1.3 Turning the Power ON/
25).
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
108