Scanning Photographs And Clippings - Fujitsu fi-7140 Operator's Manual

Chapter 4 Various Ways to Scan
4
Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
The images on the front and back are merged into a single image.
ATTENTION
 A line or a gap may appear between the front and back side
images.
Also when you scan thick papers, images on both left and right
may skew towards each other from the top.
These symptoms may be improved when you perform the
following:
- Fold the document tightly
- Align the edges of the document neatly with the edges of the
Carrier Sheet
- Turn over the Carrier Sheet to the other (reverse) side
 When [Automatic] is specified for [Paper Size], the closest
standard size (A3, B4 or Double Letter) is selected from the
same drop-down list. Note that the size of the image may
become smaller than the original document depending on the
document scanned.
Example: When you scan an A3 size document whose content
is printed to fit A4 size in the center
The image is output in B4 size.
To output the scanned image in the actual size of the document,
specify the document size for [Paper size].
 Part of the image around where the document is folded may
appear missing. In that case, set the document so its edge is
about 1 mm inside from the edge of the Carrier Sheet.
 When [Black & White] is specified for [Image Mode], a shadow
may appear on the edges around the document that is
scanned.

Scanning Photographs and Clippings

Using the Carrier Sheet allows you to scan documents that
can be damaged quite easily such as photographs, or
documents that are difficult to load directly such as newspaper
clippings.
1
Place the document inside the Carrier Sheet.
Place it against the top center of the Carrier Sheet.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
59