Scanning Does Not Start - Fujitsu fi-7140 Operator's Manual

Chapter 7 Troubleshooting

Scanning does not start.

Did you unlock the transport lock switch?
(fi-7240)
Yes
Is the document loaded in the ADF paper chute (feeder)
correctly?
Yes
Is the ADF closed properly?
Yes
Is the USB cable connected properly?
Yes
Is the connector on the USB cable broken or damaged?
No
Does scanning start after turning the scanner off then back
on?
No
Turn off the scanner, and unlock the transport lock switch.
For details about how to turn off the scanner, refer to
No
OFF" (page 23).
For details, refer to "Installing the Scanner" in Getting Started.
Reload the document in the ADF paper chute (feeder).
No
Close the ADF firmly.
If the document is caught in the ADF, remove the document and close the ADF.
No
Connect the USB cable properly.
For details, refer to "Connecting the Cables" in Getting Started
No
Use a new cable and make sure that it is connected properly.
Yes
The scanner is operating correctly.
Yes
If the problem persists, check the items in
Service Provider" (page 119)
an authorized FUJITSU scanner service provider.
"1.3 Turning the Power ON/
.
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
102