Shortening The Scanning Intervals [Pre-Pick] - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings

Shortening the Scanning Intervals [Pre-Pick]

"Pre-pick" refers to feeding the document to the starting
position for scanning before the next scan.
Enabling [Pre-Pick] shortens the interval between scanning
each document.
1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2
From the listing on the left, select [Device Setting 2] 
[Pre-Pick].
3
Specify whether or not to enable pre-pick.
Select [Yes] or [No].
HINT
 If you cancel in the middle of scanning while pre-pick is
enabled, you will have to remove the pre-picked document,
then load the document again.
 This setting can also be configured in the scanner driver. Note
that priority is given to the scanner driver setting.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
146