Chapter 1 Scanner Overview
1.3 Turning the Power ON/OFF
This section explains how to power on/off the scanner.
HINT
The method by which the scanner is powered on/off can be specified
from one of the following:
Press the [Power] button on the operator panel
Use an AC power strip to control power supply for peripherals such
as a scanner in accordance with the computer's power.
Turn on/off the scanner in accordance with the computer's power.
For details, refer to
"Method of Turning the Scanner ON/OFF [Power
SW Control]" (page
160).
How to Turn the Power ON
1
Press the [Power] button on the operator panel.
The scanner is turned on, and the [Power] button lights in green.
During initialization, the Function Number Display on the operator
panel changes in the following order: "8" "P" "0" "1". The
scanner is ready when "1" is shown on the Function Number
Display.
HINT
When the [Power] button is pressed, the LED indicator lights for a
moment. Note that it is due to an initial diagnosis and not a failure.
Contents
Index
Introduction
Scanner
Overview
How to Load
Check
Documents
How to Use the
Function
Operator Panel
Send to
Various Ways to
Scan
Scan
/Stop
Daily Care
Power
Replacing the
Consumables
[Power] Button
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
23