Chapter 2 How to Load Documents
How to Load Documents
1
Pull out the chute extensions according to the length of
the document.
For details, refer to
"1.6 Setting Up the ADF Paper Chute (Feeder)"
(page
27).
2
Bring down the stacker, slide out the stacker extension 1
and stacker extension 2 towards you, and lift up the
stopper according to the length of the document.
For details, refer to
"1.7 Setting Up the Stacker" (page
3
Load a document in the ADF paper chute (feeder).
Load a document face-down in the ADF paper chute (feeder).
ATTENTION
Remove all paper clips and staples. Reduce the number of sheets
if a multifeed or pick error occurs.
4
Adjust the side guides to the width of the document.
Do not leave space between the side guides and the document.
Otherwise, the document may be fed skewed.
28).
5
Scan the document with the image scanning application.
For details, refer to the image scanning application manual.
Introduction
Scanner
Overview
Side Guides
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
TOP
Contents
Index
Appendix
Glossary
39