Operational - Fujitsu fi-7140 Operator's Manual

Chapter 4 Various Ways to Scan
Ignoring Multifeed for a Set Pattern
If you attempt to scan a document with an attachment such as
sticky note, receipt, or photo while multifeed detection is
enabled, the scanner may falsely recognize this as a multifeed
error and stop the scan. To scan these types of documents,
the "Intelligent Multifeed Function" is available.
There are two modes in this function. In one mode, you can
suppress multifeeds forcibly by using the operator panel on
the scanner. In the other mode, you can suppress multifeeds
automatically by letting the scanner memorize the location and
the length of the attachment.
Sticky Note
Receipt
or Photograph
Document
Intelligent Multifeed Function
The following three modes are available:
Mode
Manual mode Checks for any paper attached every time a
(Bypass by front multifeed occurs, and continues scanning.
panel button)
Auto mode 1 Used to scan documents with paper of the same
(Bypass by size attached in the same location.
combination of
length and position)
Auto mode 2 Used to scan documents with paper of different
(Bypass by length) sizes attached in different locations.
ATTENTION
Irregular images may be output when multifeeds occur.
Select the mode in the Software Operation Panel.
For details, refer to "Specifying an Area Not to Detect Multifeed
[Intelligent Multifeed Function]" (page
Description
157).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
69