Device Setting 2 - Fujitsu fi-7140 Operator's Manual

Chapter 8 Operational Settings

Device Setting 2

1
Start up the Software Operation Panel.
For details, refer to "8.1 Starting Up the Software Operation Panel"
(page 123).
2
From the listing on the left, select [Device Setting 2].
The settings that are currently configured in [Device Setting 2] are
listed on the right of the window.
Items that can be configured in the above window are shown in the
next page.
HINT
 The Software Operation Panel settings can be restored to the
factory default.
To restore the settings to the factory default, click the [Default]
button. After a message is displayed, click the [OK] button.
Note that the settings you have configured will be cleared.
 The Software Operation Panel settings can be backed up.
To back up the settings, click the [Save] button, then specify the
file name and click the [Save] button in the displayed window.
 You can use a backup file of the Software Operation Panel
settings to restore the settings on other scanners only if the
scanner type is the same.
To restore the settings, click the [Restore] button, then specify
the backup file and click the [Open] button in the displayed
window. After a message is displayed, click the [OK] button.
Note that restoration cannot be performed for other types of
scanners.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
132