Operational - Fujitsu fi-7140 Operator's Manual

Chapter 5 Daily Care
4 Put a piece of cloth moistened with Cleaner F1 or a sheet of
Cleaning Wipe against the roller surface, and wipe horizontally.
Wipe off any dirt or dust on the surface by pressing the [Send to]
and [Scan/Stop] buttons at the same time to rotate the rollers.
Make sure that it is wiped properly because black residue on the
roller will affect the feeding performance.
As a guideline, pressing the [Send to] and [Scan/Stop] buttons
seven times simultaneously will rotate the feed/eject rollers one
revolution.
4
Close the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page
Be careful not to have your fingers caught
when closing the ADF.
ATTENTION
Confirm that the ADF is closed properly. Otherwise, the document
may not be fed into the ADF.
5
Reset the cleaning counter in the Software Operation
Panel.
For details, refer to "Resetting the Sheet Counters" (page
Cleaning the Flatbed (fi-7240)
The flatbed should be cleaned with a piece of cloth moistened
with Cleaner F1, or a sheet of Cleaning Wipe.
1
Open the document cover.
For details, refer to
7240)" (page
2
Clean the following locations with a cloth moistened with
25).
Cleaner F1 or a sheet of Cleaning Wipe.
Document Pad
Plastic Frame
138).
ATTENTION
Be careful not to let the cleaner in between the document bed and
the plastic frame.
"1.5 Opening/Closing the Document Cover (fi-
26).
Document
Bed
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
80