Operational - Fujitsu fi-7140 Operator's Manual

Chapter 3 How to Use the Operator Panel
Indications on Function Number Display
Display
8 Displayed when the scanner is turned on.
P Indicates that the initialization is in process after the
scanner is turned on.
0 Indicates that the initialization is in process and is near the
end of process after the scanner is turned on.
1 Ready to start scanning.
Indicates that the initialization was successfully completed
after the scanner is turned on.
This status is referred to as "ready status".
Function After multifeed is detected, the function number flashes.
number This indicates that the process to determine whether or not
(such as to memorize the overlap pattern is in progress.
"1") For details, refer to "Ignoring Multifeed for a Set Pattern"
Flashing (page 69).
c Indicates that the ADF is open in ready status.
Flashing In this case, the LED indicator also flashes.
When the ADF is closed, the display returns to the ready
status ("1").
For details about how to close the ADF, refer to
Opening/Closing the ADF" (page
If the display does not return to the ready status ("1") even
after the ADF is closed, turn the power off then back on. If
the problem still persists, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service provider.
P Indicates that the [Send to] button was pressed to pause
Flashing the scan.
Press the [Scan/Stop] button to resume the paused scan.
Description
"1.4
25).
Display Description
J Indicates that a temporary error occurred during scanning.
U The letter "J" or "U" and an error code appear alternately.
For more details about the errors, refer to
Errors" (page 95).
Press the [Scan/Stop] button or the [Send to] button in this
status to return to the ready status ("1").
E Indicates that a device error (alarm) occurred during
F initialization or scanning.
C The letter "E", "F", "C", "H" or "L" and an alarm number
H appear alternately.
A For more details about the errors, refer to
L (page 96).
Press the [Scan/Stop] button or the [Send to] button in this
status to return to the ready status ("1").
When this alarm occurs, turn the power off then back on. If
the problem still persists, contact your FUJITSU scanner
dealer or an authorized FUJITSU scanner service provider.
None Switches off when the scanner enters power saving mode.
TOP
Contents
Index
Introduction
"Temporary
Scanner
Overview
How to Load
Documents
How to Use the
"Device Errors"
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting

Operational

Settings
Appendix
Glossary
53