E" (Or Other Numbers/Letters) Is Already Displayed On The Function Number Display After Power-On - Fujitsu fi-6110 Operator's Manual

Chapter 8 Troubleshooting
"E" (or other numbers/letters) is already
displayed on the Function Number Display after
power-on.
Does the problem persist after turning the power off then
back on?
Yes
Is "c" flashing on the Function Number Display, and is the
Check LED flashing as well?
No
Is "h" displayed on the Function Number Display during
scanning?
No
The scanner is operating correctly.
No
Close the ADF properly.
For details, refer to "How to Close the ADF" (page
Yes
If the display does not return to ready ("1") after closing the ADF, check the items
in "8.4 Before You Contact the Scanner Service Provider" (page 121)
contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service
provider.
There is no problem. The scanner is operating in protection mode. It will return to
normal when you continue scanning. Note that the interval to feed the documents
Yes
becomes longer in protection mode.
If the problem persists, check the items in
Service Provider" (page 121)
an authorized FUJITSU scanner service provider.
19).
"8.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
Configuring the
Scan Settings
first, then
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
112