10. DRIVE AND DRIVEN PULLEY
Install the new driveshaft bearing into the left
crankcase cover using a special tool.
Special tool:
Oil seal & bearing install
INSTALLATION
Installation is in the reverse order of removal.
*
Clean the gasket on the left crankcase
before installation.
DRIVE PULLEY
REMOVAL
Remove the left crankcase cover (page 10-3).
Hold the drive pulley face with the special
tool and loosen the drive pulley face nut.
Special tool:
Universal holder
Remove the nut, washer and drive pulley
face.
10-5
E014
Nut/Washer
E017
XCITING 500
Bearing Install
Drive Pulley Face
Universal Holder