10
. DRIVE AND DRIVEN PULLEY
XCITING 500
Drive Belt
Check the drive belt for cracks, separation or
abnormal or excessive wear.
Attach the suitable plates ad shown.
Measure the drive belt width.
Service limit: 27.9 mm (1.116 in)
Remove the clutch/driven pulley, then replace
the drive belt if necessary.
Oil Seals
ASSEMBLY
Clean any oil from the drive belt sliding
surfaces on the driven face.
Apply grease to new oil seal lips and install
into the movable driven face.
Coat new O-rings with grease and install
them into the movable driven face grooves.
O-rings
10-18