KYMCO XCITING 500 Service Manual page 248

14.STEERING HANDLEBAR/FRONT WHEEL/
FRONT SHOCK ABSORBER
Align the pin on the right handlebar switch
housing with the hole on the steering handle.
Install the screws and tighten the forward
screw first, then tighten the rear screw.
Align the pin on the rear master cylinder
holder with the hole on the handlebar.
Install the front master cylinders and holder
with the "UP" mark facing up.
Install the bolts and tighten the upper bolt
first then tighten the lower bolt to the
specified torque.
Torque: 12 N•m (1.2 kgf•m, 9 lbf•ft)
Hole
Screws
Pin "UP" Mark
Hole
XCITING 500
Pin
14-18