KYMCO XCITING 500 Service Manual page 328

19
. ELECTRIC STARTER
STARTER RELAY SWITCH
INSPECTION
Remove the luggage box (page 2-3).
Retracted the side stand.
Turn the ignition switch to "ON" and engine
stop switch on.
Squeeze the rear brake lever fully and push the
starter switch.
The coil is normal if the starter relay switch
clicks.
If you do not hear the switch click. Inspect the
relay switch using the procedure below.
GROUND LINE INSPECTION
Disconnect the starter relay switch connector.
Check for continuity between the Green wire
terminal and ground.
There should be continuity.
VOLTAGE INSPECTION
Connect the starter relay switch connector.
Turn the ignition switch ON and engine stop
switch to RUN.
Measure the starter relay switch Yellow/Red
wire terminal and ground.
If the battery voltage appears only when the rear
brake lever is squeezed fully and starter switch
is pushed, the circuit is normal.
19-7
XCITING 500
Starter Relay Switch
Starter Relay Connector
Starter Relay Switch