Interrupting The Copy Job - Fuji Xerox DocuCentre-IV C2263 User Manual

3 Copy
2
Select [Change Quantity].
3
Specify the number of copy sets with the numeric keypad.
The new quantity must include the number of copies that have already been printed. You
cannot enter a number less than the number of copies that have already been printed.
4
Press the <Start> button.
Note

Interrupting the Copy Job

3
You can temporarily stop the copy job to have the machine process another job.
Important • Press the <Interrupt> button only after all the documents have been scanned. The machine does not
1
Press the <Interrupt> button.
The <Interrupt> button lights up to indicate
that the machine is in the Interrupt mode.
2
Load a document and set features if necessary.
3
Specify the number of copy sets with the numeric keypad.
4
Press the <Start> button.
5
After you have finished making the interrupt copy, press the <Interrupt> button.
The <Interrupt> button goes out to indicate that the Interrupt mode is exited.
Note
6
Press the <Start> button.
The suspended copy job is resumed.
82
• If you enter the same value as the number of copies that have already been printed, the machine
will not execute a copy job even when you press the <Start> button.
accept another job while it is scanning the documents, or [Next Original] has been selected.
• If you used the document glass to copy the document, remove the document from the document
glass.
1 2 3
4 5 6
7 8 9
0 #
C
<Interrupt> button