Store To Usb - Fuji Xerox DocuCentre-IV C2263 User Manual

5 Scan

Store to USB

This section describes the procedure to select features on the [Store to USB] screen. The
Store to USB service allows you to scan documents and save the scanned data to a USB
memory device. The following describes features available on the [Store to USB] tab.
Important • Before removing the USB memory device, make sure that the screen indicating that data is being
Note
5
You can customize the layout of the features displayed on the [Store to USB] screen. For more information, refer to "5 Tools"
> "Scan Service Settings" > "Screen Defaults" > "1st Tab - Features Allocation" in the Administrator Guide.
1
Insert the USB memory device into the USB memory slot on the control panel.
2
One of the following occurs.
The [USB Memory Device Detected] screen appears.
The [Store to USB] screen appears.
The [Media Print - Text] screen appears.
The [Media Print - Photos] screen appears.
The screen display does not change.
Note
304
Save in (Specifying a Storage Location in the USB Memory Device).............................................................................. 308
Details (Displaying the Details of a Storage Location in the USB Memory Device).................................................... 309
Preview (Previewing the Scanned Images during a Scan Job) ......................................................................................... 310
Color Scanning (Selecting an Output Color) ......................................................................................................................... 310
2 Sided Scanning (Scanning Both Sides of a Document) .................................................................................................. 310
Original Type (Selecting the Document Type)...................................................................................................................... 310
File Format (Selecting a File Format for Output Data)....................................................................................................... 310
transferred is not displayed. If you remove the USB memory device while the data is being stored,
the data in the device may be damaged. You can also view the [Job Status] screen to confirm if the
data has been stored to the USB memory device.
• This feature may not be available depending on the setting in the CentreWare Internet Services. For
more information, refer to "6 CentreWare Internet Services Settings" > "Configuring Machine
Settings Using CentreWare Internet Services" in the Administrator Guide.
• An optional component is required to use this service. For more information, contact our Customer
Support Center.
• A USB memory device and the Memory Card Reader cannot be used simultaneously. If they are
connected simultaneously, proper operation cannot be guaranteed.
• A USB memory device encrypted with software is not supported.
• Use the following USB memory devices:
- A formatted USB memory device
- A USB 2.0 compliant memory device (USB 1.1 is not supported.)
- A USB memory device with a storage capacity of up to 128 GB
• Commercially available Memory Card Readers with a single slot*
Text service, but its safe performance is not guaranteed.
When a Memory Card Reader with multiple slots*
which slot is available differs according to the types of Memory Card Readers, and a slot of a medium
or memory card that you want to use is not always available for the machine. Its safe performance
is not guaranteed, either.
*1 : A medium or memory card that has one slot. Some allow only one type of a medium or memory card, while
others allow more than one types (ex. SD card, xD-Picture Card).
*2 : A medium or memory card that has two or more slots.
• The behavior depends on settings. Ask your system administrator for more information.
• When a USB memory device is inserted into the USB memory slot during the Energy Saver mode, the
touch screen does not light. After exiting the Energy Saver mode by pressing the <Energy Saver>
button, insert the USB memory device again or select [Store to USB] on the [Services Home] screen.
For information on other ways to exit the Energy Saver mode, refer to "Exiting the Energy Saver
Mode" (P.58).
1
can be used for the Media Print -
2
is used, only one particular slot is available. And