Step 4 Starting The Fax Job - Fuji Xerox DocuCentre-IV C2263 User Manual

For information how to specify a fax number using the Address Book, refer to "Specifying a Destination Using the Address
Book" (P.187).
For information how to specify a fax number using the speed dialing, refer to "Speed Dialing (Specifying a Destination Using
an Address Number)" (P.191).
For information how to specify a fax number using one touch buttons, refer to "Specifying a Destination using a One Touch
Button" (P.195).
For information on the Internet Fax, refer to "About Internet Fax" (P.168).
For information on the IP Fax (SIP), refer to "Internet Fax/Fax/IP Fax (SIP) (Selecting Internet Fax/Fax/IP Fax (SIP))"
(P.186).

Step 4 Starting the Fax Job

The following describes how to start a fax job.
1
Press the <Start> button.
Important • If the document has been loaded in the
Note
If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set of
data.
2
While documents are being scanned, select
[Next Original].
Note
is used or not in the System Administration mode. For more information, refer to "5 Tools" > "Fax
Service Settings" > "Fax Control" > "Chain Dial" in the Administrator Guide.
document feeder, do not hold down the
document while it is being conveyed.
• Depending on the settings, the screen to re-
enter the recipient may be displayed after
pressing the <Start> button. In this case, re-
enter the recipient.
• If a problem occurs, an error message
appears on the touch screen. Solve the
problem according to the message.
• When using the document feeder, load the
next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no operation is
performed during a certain period of time,
the machine automatically assumes that
there are no more documents.
• You can change the scan settings of the next document by selecting [Resolution], [Original Size] and
[Lighten/Darken] that are displayed after selecting [Next Original].
Fax Procedure
1 2 3
4 5 6
7 8 9
0 #
C
<Start> button
163
4