Fuji Xerox DocuCentre-IV C2263 User Manual page 75

2
Load the document face up (when the
document is 2-sided, load the front side up) in
the center of the document feeder.
Note
3
Adjust the document guides to match the size
of the document loaded.
4
Open the document stopper.
Document Glass
The document glass supports a single sheet, a book, or other similar documents with sizes
from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard document size,
refer to "Original Size (Specifying the Scan Size for the Document)" (P.113).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common Service Settings" > "Other
Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may break
the glass and cause injuries.
• The Confirmation indicator lights up when
the document is loaded correctly. If the
indicator does not light, load the document
again.
Copying Procedure
Confirmation indicator
3
75