Figure 11-25 Compiler Tray - Xerox Phaser 7700 Service Manual

RRP 83 Compiler Tray

Figure 11-25 Compiler Tray

Removal
1. Remove all covers (RRP 72, on page 308).
2. Remove the Finisher Control Board Shield (RRP 77, on page 314).
3. Disconnect P848.
4. Remove Set clamp solenoid connector.
5. Remove the Staple Unit (RRP 82, on page 320).
6. Remove two screws from the bottom of the tamper assembly, front and rear.
7. Push the wiring harness into the printer frame.
8. Tilt the carriage up and slide straight back letting the carriage drop down in
the frame, then slide straight out the stapler cavity.
11-322
Phaser 7700 Color Laser Printer