Xerox Phaser 7700 Service Manual page 82

Error Chain /
Code Link
32 04-348 ERROR 32 UNEXPECTED Accumulator Belt EDGE SENSOR
FAILURE
Remove the Accumulator Belt Assembly (RRP 51, on page 7-200).
Inspect the connector for damage.
Is the connector in good condition?
Yes No
Replace the Accumulator Belt Assembly (RRP 51, on page 7-200).
Inspect the mating connector inside the printer for corresponding damage. Repair or
replace the harness between the Accumulator Belt and connector J605
(see figure page 3-47).
Reinstall the Accumulator Belt Assembly.
Switch printer power ON.
Remove the Rear Cover (RRP 1, on page 7-140).
Remove the Rear Shield (RRP 9, on page 7-149).
Measure the voltage between the Engine Control Interface Board P533A-2(+)
(see figure page 3-47) and frame ground.
Does the voltage measure between +1 VDC and 3 VDC?
Yes No
Measure the voltage between the Engine Control Interface Board P533A-3(+)
(see figure page 3-47) and frame ground.
Does the voltage measure +5 VDC?
Yes No
Replace the Engine Control Board (RRP 42, on page 7-190).
If the problem persists, replace the Engine Control Interface Board
(RRP 43, on page 7-191).
Measure the voltage between the Engine Control Interface Board P533A-1(+)
(see figure page 3-47) and frame ground.
Does the voltage measure 0 VDC?
Yes No
Replace the Engine Control Board (RRP 42, on page 7-190).
If the problem persists, replace the Engine Control Interface Board
(RRP 43, on page 7-191).
Replace the Accumulator Belt Assembly (RRP 35, on page 7-180).
If the problem persists, repair or replace the wiring harness between the Engine Interface
Board and the Accumulator Belt Assembly.
If the problem persists, replace the Engine Control Board (RRP 42, on page 7-190).
If the problem persists, replace the Engine Control Interface Board (RRP 43, on page 7-191).
Service Quick Reference Guide - Diagnostics, Error Codes & Messages
Front Panel Message
2-59