Figure 7-56 Print Cartridge Drive Assembly; Rrp 53 Print Cartridge Drive Assembly - Xerox Phaser 7700 Service Manual

RRP 53 Print Cartridge Drive Assembly

Figure 7-56 Print Cartridge Drive Assembly

Removal
1.
Remove the Rear Cover Assembly (RRP 1, on page 7-140).
2.
Remove the Right Cover Assembly (RRP 2, on page 7-141).
3.
Remove the 3.3 VDC and 5 VDC Low-voltage Power Supply Bracket Assembly
(RRP 45, on page 7-194)
4.
Remove the 24 VDC Low-voltage Power Supply (RRP 47, on page 7-196).
5.
Remove the T2 High-voltage Power Supply (RRP 48, on page 7-197).
6.
Disconnect the wiring harness to the Print Engine Drive Assembly.
7.
Remove the two screws securing the finisher connector (now accessible after
removing the Right Cover Assembly) and let it hang loose.
8.
Remove the screw that is accessible through the frame access hole near the
finisher connector (now accessible after removing the Right Cover Assembly).
9.
Remove the remaining seven screws that secure the Print Cartridge Drive
Assembly to the printer frame.
10.
Lift the Print Cartridge Drive Assembly up and out of the printer.
7-202 Phaser 7700 Color Laser Printer
S7700-006