RRP 41 Electrical Chassis (Card Cage) Assembly
Figure 7-44 Electrical Chassis Assembly
Removal
Caution
Before removing the Electrical Chassis Assembly, it is
recommended to store Engine NVRAM data on the Hard Drive
(see Store Engine NVRAM on page 6-136).
1.
Remove the Right Cover (RRP 1, on page 7-140).
2.
Remove the Top Cover (RRP 3, on page 7-142).
3.
Remove the Rear Cover (RRP 5, on page 7-144).
4.
Remove all three Shields (RRP 10, on page 7-150).
5.
Remove the Image Processor Board (RRP 39, on page 7-186).
6.
Disconnect the nine wiring harnesses along the edges of the engine controller
board. Seven of these harnesses are in front of the controller board. The other
two are on the left side.
Note
Two of the engine control connectors have connector locks. There
is one harness clip to release.
7-188
Phaser 7700 Color Laser Printer