RRP 44 T1 and T3 High-voltage Power Supplies
Figure 7-47 T1 and T3 High-voltage Power Supplies
Removal
1.
Remove rear cover and shield (RRP 9, on page 7-149).
Note
Do not disconnect the T1 wire harness at P572 (blue connector).
1.
Disconnect the wiring harness at P/J501 and P/J574.
2.
Disconnect the high-voltage wires to the Transfer Roller and at DTS (J801).
3.
Remove the three screws that secure the high-voltage power supply assembly
to the printer frame and tilt the entire high-voltage assembly down.
Note
If complete removal is not required, there is a restraining strap
on the back side of the assembly to hold the assembly in a
horizontal position.
4.
Disconnect the T1 high-voltage wire harness at P580 and remove the wiring
harness from the clip grommet.
5.
Disconnect the T3 high-voltage wire harness at P581 and remove the wiring
harness from the clip grommet.
6.
Remove the high-voltage power supply assembly.
7.
Disconnect the interconnecting wiring harness at P573 on the T3 power supply
board.
8.
Remove the appropriate power supply board(s) from the assembly.
7-192
Phaser 7700 Color Laser Printer