RRP 4 Front Panel Assembly
Access
Holes
Figure 7-4 Control Panel Assembly
Removal
Warning
Turn off the printer and disconnect the power cord.
1.
Open the Front Door.
2.
Release the Front Panel Assembly by inserting a screwdriver or key into the
two access holes indicated in the illustration and push the tangs inward to
release.
3.
Lift up the panel slightly and unplug the cable connected to the Front Panel.
4.
Release the two tabs on the left-hand end of the Front Panel Assembly and
remove.
Service Quick Reference Guide - Removal & Replacement Procedures
S7700-270
7-143