Xerox Phaser 7700 Service Manual page 228

4.
Remove RH Cover Assembly (RRP 2, on page 7-141).
5.
Remove the Main Lever.
6.
Remove the e-clips and washers from the RH Lift Jack Assembly roller guides.
7.
Remove the four screws that hold the RH Lift Jack Bracket and remove the
bracket.
8.
Remove the two screws holding the Waste Auger Assembly.
9.
Remove the four screws holding the RH Lift Jack Bracket and remove from the
printer.
Note
When reinstalling the RH Lift Jack Assembly install the screws as
follows: Upper Left, Upper Right, then the lower screws.
Note
When reinstalling the RH Lift Jack Assembly ensure that the Jack
racks protrude evenly before returning the Main Lift Lever to its
upright position.
Removal - LH Lift Jack Assembly
1. Remove the Accumulator Belt Assembly (RRP 35, on page 7-180).
2. Remove the Print Cartridges and protect from the light.
3. Remove the Main Lever Assembly (RRP 55, on page 7-204).
4. Remove the LH Lever Hinge.
5. Remove the LH Cover Assembly (RRP 14, on page 7-154).
6. Remove the Transport Registration Assembly (RRP 20, on page 7-161).
7. Remove the Mark-On-Belt (MOB) Sensor Assembly (RRP 32, on page 7-177).
8. Reach inside the LH cover cavity and remove the black print cartridge rail by
pushing on the rail slot while pulling on the rail.
Caution Cover the developers with multiple sheets of stiff paper or
cardboard to prevent damage to the developer rollers and to catch
e-clips and washers loosened in the next step.
9. Remove the e-clips and washers from the LH Lift Jack Assembly roller guides.
10. Remove the four screws that hold the LH Lift Jack Bracket and remove the
bracket.
11. Remove the four screws holding the LH Lift Jack Bracket and remove from the
printer.
Note
When reinstalling the LH Lift Jack Assembly, install the screws as
follows: Upper Front, Upper Rear, then the lower screws.
Note When reinstalling the RH Lift Jack Assembly, ensure that the Jack
racks protrude evenly before returning the Main Lift Lever to its
upright position.
Service Quick Reference Guide - Removal & Replacement Procedures 7-205